User manual for "InTouch ELD - iOS"

Below you will find the vendor provided user manual for the ELD product "InTouch ELD - iOS".

For contact information and additional devices produced by the same vendor see their page InTouch.

Installation of IOSiX Device for use with InTouch ELD

 Open InTouch ELD
 Login to the app using a driver user account
 On the main dashboard, tap the Connect button which is located below the app header to
display the Connect to Vehicle dialog.
 At this point, 2 options were present in order to establish a connection to the VBUS device:
Manual Connection and Auto Connection.
A. Manual Connection

 Tap on the Manual Connection button

 Select VBUS Device - IOSix

 Tap on the Next button

 If the Bluetooth of the device is disabled, the Bluetooth Permission
Request dialog will be displayed.
 Tap on the Yes button to enable the Bluetooth of the device

 Choose the correct Bluetooth device from the list

 It will then display the VBUS Progress dialog upon establishing a connection to
the selected VBUS device along with a Stop Connection and Ok buttons:
A. Tap Stop Connection button to stop establishing VBUS connection.
B. Tap OK button to hide the VBUS Progress dialog while establishing
VBUS connection.

 If the VBUS connection results to an error (given the following situations below),
an error dialog will display.
 VBUS Data Error
i.
Interrupted Internet Connection

ii.

VBUS Power Failure

Note: The app will automatically disconnect from the device after
attempting to connect for 1 minute and 30 seconds without
receiving any data from the VBUS device.
 Upon establishing a connection to the VBUS device you should hear a tone letting
you know that device is now connected.
 To check if you are connected, navigate to the Main Dashboard and the VBUS
status indicator should be displayed as Connected

which is located on

the app header.

 You can also check on the Android Notification Bar and you should see the
VBUS Service status as Connected.

 The device and the application are now connected.
B. Auto Connection
 Tap on the Connect button
 The VBUS Progress dialog will then display
 Upon establishing a connection to the VBUS device, You should hear a tone
letting you know that device is now connected.
 Prerequisites to successfully perform Auto Connection
 Create a Pre-configured device in the Portals Equipment
Management Page or in the Apps Manage Vehicles/Trailers
screen
 Set the ELD Configurations
Note: Only users allowed to Manage Equipment can create
equipment in the app.
© ELD.report 2025

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.