User manual for "InTouch ELD - iOS"

Installation of Geometris Device for use with
InTouch ELD
Connect the device using an OBD to J1939 adapter cable.






Open InTouch ELD
Login to the app using a driver user account
On the main dashboard, tap the Connect button which is located below the app header
to display the Connect to Vehicle dialog.
At this point, 2 options were present in order to establish a connection to the VBUS
device: Manual Connection and Auto Connection.
a. Manual Connection

 Tap on the Manual Connection button

 Select VBUS Device - Geometris

 Tap on the Next button
 If the Bluetooth of the device is disabled, the Bluetooth Permission
Request dialog will be displayed.
 Tap on the Yes button to enable the Bluetooth of the device

 Choose the correct Bluetooth device from the list

 It will then display the VBUS Progress dialog upon establishing a
connection to the selected VBUS device along with a Stop Connection
and Ok buttons
b. Tap Stop Connection button to stop establishing VBUS
connection.
c. Tap OK button to hide the VBUS Progress dialog while
establishing VBUS connection.

 If the VBUS connection results to an error (given the following situations
below), an error dialog will display.
 VBUS Connection Error
i.
Interrupted Internet Connection
ii. VBUS Power Failure

Note: The app will automatically disconnect from the device after attempting to connect for 1
minute and 30 seconds without receiving any data from the VBUS device.

 Upon establishing a connection to the VBUS device you should hear a tone
letting you know that device is now connected.

 To check if you are connected, navigate to the Main Dashboard and the VBUS
status indicator should be displayed as Connected
app header.

which is located on the

 You can also check on the Android Notification Bar and you should see the
VBUS Service status as Connected.



The device and the application are now connected.

b. Auto Connection


Tap on the Connect button



The VBUS Progress dialog will then display



Upon establishing a connection to the VBUS device, You should hear a tone
letting you know that device is now connected.


Prerequisites to successfully perform Auto Connection
 Create a Pre-configured device in the Portals Equipment Management
Page or in the Apps Manage Vehicles/Trailers screen
 Set the ELD Configurations