User manual for "ROBINHOOD ELD"

DRIVER MANUAL
DOWNLOAD ROBINHOOD ELD APPLICATION

1. Search for "Robinhood ELD"
in Google Play or Apple Store

2. Tap INSTALL to download
the app

3. After the application is installed, please allow the app to use your location, send notications,
and use Bluetooth. If you don't accept some of them, the app will not work.

Allow Robinhood ELD 

Robinhood ELD

Robinhood ELD

INSTALLATION PROCESS OF THE ELD DEVICE

1. In order to connect the ELD device to the app, please make sure that your truck
engine is ON.

2. Locate the diagnostic port inside your vehicles cabin. The diagnostic port is
typically located in one of the following places:
a. Under the left side of the dashboard
b. Under the steering wheel
c. Near the drivers seat
d. Under the drivers seat

3. Plug the connector rst in the ELD devices port, plug into the diagnostic port of your
vehicle and twist the plug base until it locks into place.

4. DO NOT pair Bluetooth in your phone/tablet settings.
The connection will be established automatically in the Robinhood ELD app.
However, if your phone/tablet prompts you or asks you for permission to turn on
Bluetooth, you need to do that since Bluetooth is needed for the device to
communicate with the app.

5. You should see a ashlight green LED, indicating that the device is powered. You
should also see a ashing red LED, indicating that the internal GPS is in
acquisition mode. A solid red LED indicates that the signal is locked, but you CAN proceed
to the next step without waiting for GPS lock. Go to the next step.

6. From this point on, the device will have and retain the information it needs, such as VIN,
to communicate with the app via Bluetooth Low Energy. Note that for power
management reasons, sometimes the LEDs will not stay on.

USING THE APPLICATION

1. To log in, type your
username and
password.

2. Select your vehicle
from the list of units.

3. Type the MAC address listed on your ELD
device in the app, using capital letters and
digits - then click Connect.

2023

4. If you get this
notication, it means
some of the items
from the following list
are not ON.

5. When you are properly
connected, you can
see the green
Bluetooth icon in the
top right corner.

6. Driving mode will
switch Automatically
after youll start
driving over 5 MPH.
DO NOT select
driving manually!

7. When the vehicle is
stopped, the driving
mode will be unlocked,
and you can change
the status.

FEATURES:
1. Internal synchronization with the engine control module
2. Automatical driving time and details recording
3. Accurate location recording
4. Electronic data transfer
5. Certication of driver records (at the end of each 24 hours)
6. IFTA reports

HOW TO SEND AN OUTPUT FILE
1. Click on the menu and select DOT inspection
2. Click on Send Logs
3. Choose Data Transfer Type

1

2

3